Wednesday, July 11, 2007



kudzu - detects and configures new and/or changed hardware on a system




kudzu detects and configures new and/or changed hardware on a system. When started, kudzu detects the current hardware, and checks it against a database stored in /etc/sysconfig/hwconf, if one exists. It then determines if any hardware has been added or removed from the system. If so, it gives the users the opportunity to configure any added hardware, and unconfigure any removed hardware. It then updates the database in /etc/sysconfig/hwconf.

If no previous database exists, kudzu attempts to determine what devices have already been configured, by looking at /etc/modules.conf, /etc/sysconfig/network-scripts/, and /etc/X11/XF86Config.


Show short usage message.
--help, -?
Print help information.
-q, --quiet
Run 'quietly'; do only configuration that doesn't require user input.
-s, --safe
Do only 'safe' probes that won't disturb hardware. Currently, this disables the serial probe, the DDC monitor probe, and the PS/2 probe.
-t, --timeout [seconds]
This sets the timeout for the initial dialog. If no key is pressed before the timeout elapses, kudzu exits, and /etc/sysconfig/hwconf is not updated.
-k, --kernel [version]
When determining whether a module exists, use the specified kernel version. (If this is not set, it defaults to the current kernel version.) Do not specify suffixes such as 'smp' or 'summit'; these are automatically searched.
-b, --bus [bus]
Only probe on the specified bus.
-c, --class [class]
Only probe for the specified class.
-f, --file [file]
Read hardware probe info from file file and do not do an actual probe.
-p, --probe
Print probe information to the screen, and do not actually configure or unconfigure any devices.

No comments: